TMONDO II® Portable Restroom Assembly Instructions 67 avenue de la Toison d’Or 1060 Brussels Belgium Tel: 0032/2-542 56 56 Fax: 0032/2-542 56 57 www.satelliteindustries.
INTRODUCTION These Assembly Instructions cover the portable restroom. Portable restrooms must be assembled according to approved assembly procedures. Avoid variations in assembly which could adversely affect product life. IMPORTANT: Do not remove shipping screw from bottom of door until instructed to in the “Install the Front Assembly” step. • The assembly procedures are written for assembly of single units.
EXPLODED UNIT ASSEMBLY DRAWING (ROTOMOLDED BASE) PARTS LIST PN 20340 REV G Page 2
EXPLODED UNIT ASSEMBLY DRAWING (DIRT BUSTER BASE) DIRECTIONS 1. JOIN PANELS TOGETHER WITH CORNER MOLDING SET REAR PANEL ON A BOX AT LEAST 40” HIGH BUT NOT WIDER THAN 41”. IF ASSEMBLING SINGLE UNITS, THE WASTE TANK WILL DO. ASSEMBLE ALL RIVETS TO WASHERS BY USING THE AIR RIVET GUN; MAKE SURE ALL RIVETS AND WASHERS ON BOTH PANELS ARE TIGHT. 2.
TIP BASE UP AND POSITION INSIDE PANELS. USING THE DRILL AND 3/8" HEX DRIVER BIT. FASTEN PANELS TO BASE WITH LAG SCREWS (PN 13860). ROTOMOLDED BASE: LOCATE DIMPLES CIRCLED ON BASE AT LOCATION SHOWN. FASTEN PANELS TO BASE WITH LAG SCREWS. FASTEN REMAINING HOLE. DIRT BUSTER BASE: FASTEN REAR PANEL FIRST. PANEL NEEDS TO BE FLUSH WITH TOP OF RUNNER. USING THE CENTER SCRIBE LINE ON BASE FASTEN PANEL WITH LAG SCREW. REPEAT ON EACH SIDE PANEL USING BOTTOM HOLES. SEE SCRIBE LINE LOCATION AS SHOWN.
4. PLACE TANK IN UNIT ATTACH TANK TO PANELS FROM OUTSIDE. IT IS IMPORTANT THAT THE TANK IS SEATED PROPERLY WHILE ATTACHING THE SIDE PANELS. HAVE ONE PERSON STAND IN TANK WHILE LAGGING PANELS TO TANK. USING THE DRIVER AND 3/8" NUT DRIVER BIT. TIGHTEN SCREWS UNTIL RUBBER WASHER BEGINS TO FLATTEN – BE CAREFUL NOT TO OVER TIGHTEN SCREWS. 5. INSTALL URINAL (IF TOILET IS ASSEMBLED WITHOUT URINAL SKIP TO #6) 6. INSTALL VENT PIPE 7.
HOOD PAPERGUARD: USING #10 (3/16”) DRILL BIT. DRILL THE (3) DIMPLES ON THE RIGHT SIDE PANEL. (SEE RESTROOM DRAWING ON PAGE 3). FASTEN WITH RIVETS AND WASHER. NOTE: IF INSTALLING OTHER OPTIONAL ACCESSORIES SUCH AS A SLIMMATE SINK; THE PAPERGUARD MAY HAVE TO BE MOVED TO A DIFFERENT LOCATION. 8. ATTACH TOILET SEAT USING A #2 PHILLIPS OR FLAT HEAD SCREWDIVER. (TIGHTEN SEAT HINGE NUT SECURELY) 9.
ROTOMOLDED BASE: INSTALL THE NUT AND BOLT IN 2ND HOLE ON LEFT FACING THROUGH HOLE BASE. (SEE PICTURE) BEFORE TIGHTENING CHECK REMAINING SCREW HOLES ON FRONT TO SEE IF THEY LINE UP WITH CORED HOLES IN BASE. IF SO CONTINUE, TIGHTEN BOLT USING 3/8 DRIVER BIT WHILE HOLDING NUT WITH A 1/2" WRENCH. IF NOT USING A 13/32 DRILL BIT ENLARGE HOLES IN FRONT. INSTALL THE LAG SCREWS USING THE 3/8 NUT DRIVER BIT. REMOVE SHIPPINGS CREW. OPEN DOOR AND INSTALL THE (2) LAG SCREWS TO DIMPLES TO INSIDE THE FACING FRAME.
