Users Manual

AC POWER CEILING FAN REMOTE CONTROL MANUAL

TR213B

LEARNING PROCESS

NOTE: The Hand Held Remote Control System is equipped with a learning frequency function which has

code combinations to prevent potential interference from other remote units.

Step: 1. Install the DC1.5V*2pcs batteries. Within 30 seconds of turning the Receivers AC power ON. Press the

transmitter’s “Fan OFF” button.

Step: 2. Hold the “Fan OFF” button for over 5 seconds, once the receiver has detected the frequency, the receiver

will make sound, Bi Bi, twice. This will indicate the receiver has learned the frequency that was previously

selected on the transmitter.

NOTE: After the AC power is on, do not press any other button on the transmitter before pressing the “Fan OFF”

button , Because doing so will cause the procedure to fail.

After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not responding

to the transmitter, please turn the power off to the receiver. And repeat step 1 and 2.

NOTE: Remove the battery if not used for long periods of time to prevent damage to the hand held remote.

FUNCTIONS OF TRANSMITTER

1、

ON/OFF - Press and release immediately to turn on or off light.

DIMMER - Press and hold to dim or brighten light to the desired level and release.

2. FAN SPEED：Pressing key s HI、MED、LOW、OFF、 , it will control receiver FAN at speed 1~3 and OFF.

3. Learning keys: Learning distance is no limition. Please press learning keys（Fan OFF）, Then receiver will remind that learning is

finished. Only transmitter was learned can control receiver.

4. It has corresponding keys LED indicator, Pressing KEY, The LED indicator will flash.

5.Timer setting：Press Keys 2hr、4hr、6hr，to set the Fan off time.

To assure continued FCC compliance:

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

PAGE 1
AC POWER CEILING FAN REMOTE CONTROL MANUAL TR213B LEARNING PROCESS NOTE: The Hand Held Remote Control System is equipped with a learning frequency function which has code combinations to prevent potential interference from other remote units. Step: 1. Install the DC1.5V*2pcs batteries. Within 30 seconds of turning the Receivers AC power ON. Press the transmitter’s “Fan OFF” button. Step: 2.
PAGE 2
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver.