Installation Instructions

CEILING FAN REMOTE CONTROLLER

LEARNING PROCESS

The Hand Held Remote Control is equipped with a learning ID function which has code combinations to prevent

potential interference from other remote units.

Step: 1. Install the batteries AAA 1.5V*2 PCS in transmitter. Within 30 seconds of turning the

Receiver AC power ON, press the transmitter LEARN button

Step: 2. Hold LEARN button about 3 seconds, once the receiver has detected the ID,

the light of ceiling fan will be blinking twice and the fan turn on low speed. This will

indicate the receiver has learned the ID that was previously selected on the

transmitter.( The 0/1 switch on the back of the transmitter is in the "0" state, and it

can be directly controlled without pairing. The 0/1 switch is in the "1" state, need to

proceed learning.)

Note: After the AC power is on, do not press any other buttons on the transmitter

before learning ok. Because doing so will cause the procedure to fail.

After completing the steps above, you should be able to operate the ceiling fan and

light. If the ceiling fan is not responding to the transmitter, please turn the power off

to the receiver and repeat step 1 and 2.

Remove the batteries if not used for long periods of time to prevent damage to the

hand held remote. The batteries must be removed from the transmitter before it is

scrapped and the batteries shall be disposed of safety.

Light function select switch:

Slide the D/O switch, located in the battery compartment, to match the bulb type in your fan.

“D”(DIMMER) for incandescent bulbs and “O”(ON/OFF) indicates compact fluorescent bulbs (CFL). Use a

small screwdriver or ballpoint pen to slide firmly left or right.

FUCNCTIONS OF TRANSMITTER

：Turn on/off ceiling fan

2. FAN SPEED(1~9 SPEED)

Press

button to increase speed and LED bar will show at same time. All

LED is brighten for the highest speed. Press button to decrease speed.

3..FAN TIMER

Setting up that the ceiling fan and light will turn off after 2, 4 or 8

hours automatically.

.: For setting natural wind that the fan speeds turn and change at random.

It’s three modes for choose. Hold the button about 3 seconds can cancel

the natural setting.

5. : Press and hold this button about 3 seconds for setting

forward/reverse airflow of ceiling fan.

PAGE 1
CEILING FAN REMOTE CONTROLLER LEARNING PROCESS The Hand Held Remote Control is equipped with a learning ID function which has code combinations to prevent potential interference from other remote units. Step: 1. Install the batteries AAA 1.5V*2 PCS in transmitter. Within 30 seconds of turning the Receiver AC power ON, press the transmitter LEARN button Step: 2.
PAGE 2
To assure continued FCC compliance: FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.