Installation Instructions

.CEILING FAN REMOTE CONTROLLER

OPERATION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

IMPORTANT POINTS TO REMEMBER:

1. Read and save these instructions.

2. Please note that all fixed wiring appliances should be installed by a qualified electrician.

3. The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall switch.

4. Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.

5. Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6. This unit is to be used for the control of ceiling fan and in an AC120V 60Hz power supply only.

7. Do not install in wet locations or immerse in water.

8. Do not pull on or cut leads shorter.

9. Do not drop or bump the unit.

10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place as this will

damage the transmitter. Dispose of used battery properly, keep the battery out of reach of children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable (rheostat)

wall control.

INSTALLATION INSTRUCTIONS

1. Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pressing the “Light Switch” after

installation.

2. Press and hold the emitter’s “SET” key for about 3S in 30 seconds of turning the Receivers AC power ON, The

receiver learn the emitter’s CODE and the emitter can remote the receiver.(FIG.1 / 2 / 3)

3. Your transmitter is ready for use after 2pc DC1.5V/ AAA, battery installation(FIG. 1)

IMPORTANT

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT (IF ANY) TO ON

POSITION BEFORE OPERATING REMOTE CONTROL.

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER

FIG. 2

FIG. 1

FIG. 3

PAGE 1
.CEILING FAN REMOTE CONTROLLER OPERATION AND INSTALLATION INSTRUCTIONS (Please keep this instruction pamphlet.) IMPORTANT YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT (IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL. IMPORTANT POINTS TO REMEMBER: 1. Read and save these instructions. 2. Please note that all fixed wiring appliances should be installed by a qualified electrician. 3. The supply to the remote control receiver should be connected through a mains switch, i.e.
PAGE 2
FUNCTIONS OF TRANSMITTER 1、 ON/OFF - Press and release immediately to turn on or off light. DIMMER - Press and hold to dim or brighten light to the desired level and release. (Only when the dip switch was set on “D” dimmer setting) 2. FAN SPEED：Pressing key s 1、2、3、4、5、6、 3. Pressing key , it will control receiver FAN at speed 1~6 and OFF. : Press and release immediately to set fan direction: 4.. Natural wind Function: Pressing key , Fan will run in natural wind. 5..