Installation Instructions

CEILING FAN REMOTE CONTROLLER

OPERATION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

IMPORTANT POINTS TO REMEMBER:

1. Read and save these instructions.

2. Please note that all fixed wiring appliances should be installed by a qualified electrician.

3.The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall

switch.

4.Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.

5.Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6.This unit is to be used for the control of ceiling fan and in an AC110V/120V 60Hz power supply only.

7.Do not install in damp locations or immerse into water. (For indoor use only.)

8.Do not pull on or cut leads shorter.

9.Do not drop or bump the unit.

10.

PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place as this

will damage the transmitter. Dispose of used battery properly, keep the battery out of reach of children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable

(rheostat) wall control.

INSTALLATION INSTRUCTIONS

1. Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pressing the “Light Switch”

after installation.

2. Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy

comes up to cover the receiver and bracket.

CODE SWITCH

1. CODE SWITCH: Codes are set by pushing dip switch up or down. It is impertive that the code used for both transmitter and

receiver is exactly the same,otherwise remote controller will not work. Please note the code switch will enable you to operate a

second remote controller independtly.For example,if you have two ceiling fans with 2 remote control units,set 2 different codes

for each set of transmitter/receivers. This meas you can operate

each ceiling fan independtly.

2. Your remote control is ready for use after battery installation.

FUNCTIONS OF TRANSMITTER

H :Turn on the fan at high speed

M : Turn on the fan at medium speed

L : Turn on the fan at low speed

OFF: Turn off the ceiling fan.

ON/OFF- Press and release immediately to turn on or off the light

DIMMER- Press and hold on to dimmer or brighten the light.

REV：Press this button to set the fan direction.

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.

Installation of Transmitter Wall

Mount Holder with two screws.

PAGE 1
CEILING FAN REMOTE CONTROLLER OPERATION AND INSTALLATION INSTRUCTIONS (Please keep this instruction pamphlet.) IMPORTANT POINTS TO REMEMBER: 1.Read and save these instructions. 2.Please note that all fixed wiring appliances should be installed by a qualified electrician. 3.The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall switch. 4.Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan. 5.
PAGE 2
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.