Installation Instructions

DC POWER CEILING FAN REMOTE CONTROL MANUAL
LEARNING PROCESS
NOTE: The Hand Held Remote Control System is equipped with a
learning frequency function which has code combinations to prevent
potential interference from other remote units. The frequency on your
Receiver and Transmitter units have been preset at the factory. We
recommend changing the frequency while installing your ceiling fan
instead of using the initial frequency set by the factory (Fig. 1) Please
use a small size tool to change the code switch setting
.
Step: 1. Within 30 seconds of turning the Receivers AC power ON.
Press the transmitter’s “ OFF” button.
Step: 2. Hold the “OFF” button for over 4 seconds, once the receiver
has detected the frequency, the receiver will make one sound, Bi and
light flicker twice and turn off,Meanwhile the fan be turn off.This will
indicate the receiver has learned the frequency that was previously
selected on the transmitter.
A:If you would like that the receiver make sound when changing function, you could turn on the sound. The
setting way is that you pressing “OFF” button about 4 seconds when you control the ceiling fan. please note that
when you reboot power.on ,you need to wait after 30 seconds to perform this operation
B:If you don’t need the receiver make sound, you can pressing “OFF” button about 4 seconds when you control
the ceiling fan.please note that when you reboot power.on ,you need to wait after 30 seconds to perform this
operation
Note: After the AC power is on, do not press any other button on the transmitter before pressing the “OFF” button
doing so will cause the procedure to fail.
After completing the steps above, you should be able to operate the ceiling fan and light If the fan is not
responding to the transmitter, please turn the power off to the receiver. And repeat step 1 and 2.
Install the DC1.5V/AAA 2PCS batteries. Remove the batteries if not used for long periods of time to prevent
damage to the hand held remote.
FUNCTIONS OF TRANSMITTER
1. F/R ：“F/R” BUTTION
shown on LCD : fan wind direction is up
shown on LCD :fan wind direction is down
2.
：“NATURAL FLOW” HI/LOW SPEED SWITCH
shown on LCD :Fan automatically change fan speed to make the natural
wind
3. FAN ： 1~6 FAN SPEED(Press this button to select desired speed, there are 6
different fan speed, release the button after setting)
shown on LCD :This symbol is full when the fan in HI speed
4. OFF ： To turn the fan off
shown on LCD : turn fan off
5. LIGHT ：To turn on and turn off the light (Light function only for fans with light kit)
shown on LCD : turn light on
shown on LCD : turn light off
6. While Battery power is low as
shown on LCD, please replace new DC1.5V/AAA batteries.