Integration Guide

SATEL-TR4+
Integration Guide, Version 1.7
34
Addressing
SL#I=xxxx
Set all addresses (RX1, RX2, TX1,
TX2) to value xxxx [0000....ffff]
"OK" or "ERROR"
Addressing
SL#P?
Get primary transmit address (TX1)
and primary receive address (RX1)
"xxxx;yyyy"
Addressing
SL#P=xxxx;yyyy
Set primary transmit address (TX1)
to value xxxx and primary receive
address (RX1) to value yyyy
[0000....ffff]
"OK" or "ERROR"
Addressing
SL#Q?
Get TX address mode
"0" = TX address OFF
"1" = TX address ON
Addressing
SL#Q=x
Set TX address ON/OFF. Values of x
are:
"0" = TX address OFF
"1" = TX address ON
"OK" or "ERROR"
Addressing
SL#R?
Get primary receive address (RX1)
"yyyy"
Addressing
SL#R=xxxx
Set receive addresses (RX1, RX2) to
value xxxx [0000....ffff]
"OK" or "ERROR"
Addressing
SL#S?
Get secondary transmit address
(TX2) and secondary receive
address (RX2)
"xxxx;yyyy"
Addressing
SL#S=xxxx;yyyy
Set secondary transmit address
(TX2) to value xxxx and secondary
receive address (RX2) to value yyyy
[0000....ffff]
"OK" or "ERROR"
Addressing
SL#T?
Get primary transmit address (TX1)
"xxxx"
Addressing
SL#T=xxxx
Set transmit addresses (TX1, TX2) to
value xxxx [0000....ffff]
"OK" or "ERROR"
Addressing
SL#W?
Get RX address mode
"0" = RX address OFF
"1" = RX address ON
Addressing
SL#W=x
Set RX address ON/OFF. Values of x
are:
"0" = RX address OFF
"1" = RX address ON
"OK" or "ERROR"
ChannelList
SL$A=1
Go to channel list default channel
"OK" or "ERROR"
ChannelList
SL$C?
Get number of channels in channel
list
decimal number
ChannelList
SL$C=nn
Set number of channels in channel
list. nn = 0...40, 0 clears the whole
list
"OK" or "ERROR"
ChannelList
SL$D?
Get channel list default channel
number
decimal number
ChannelList
SL$D=n
Set channel list default channel, n is
channel number
"OK" or "ERROR"
ChannelList
SL$E=1
Search free channel
Modem searches for next traffic-
free channel. Listening time of
traffic is about 2 seconds
"OK" followed by “channel
n is free”
Value of n is channel
number of next free
channel on channel list