Integration Guide

SATELLINE-M3-TR3
and –TR4
Integration Guide, Version 1.6
29
ModemInfo
SL%4="data"
Set arbitrary data (max 25
characters) in memory location 4
"OK" or "ERROR"
ModemInfo
SL%D?
Get Modem Type
Depends on model, for
example "M3-TR3"
ModemInfo
SL%H?
Get logic hardware version
Hardware info
ModemInfo
SL%S?
Get Serial Number
Serial number of radio
modem
ModemInfo
SL%V?
Get firmware revision information
For example
"V07.22.2.3.0.2"
OperationMod
e
SL+S=x
Activate sleep mode
"1" turn the modem into a state
where it will hold serial interface
parts of the module on, wakeup
will take approx. 30ms
"5" Turns ON Power save mode.
"6" Turns OFF Power save mode.
“OK” or “ERROR”
RadioFreq
SL!D?
Get lower limit of frequency band
1
"nnn.nnnnn MHz"
RadioFreq
SL!U?
Get upper limit of frequency band
1
"nnn.nnnnn MHz"
RadioFreq
SL!W?
Get lower limit of frequency band
2
"nnn.nnnnn MHz"
RadioFreq
SL!Y?
Get upper limit of frequency band
2
"nnn.nnnnn MHz"
RadioFreq
SL&F?
Get active frequency
"nnn.nnnnn MHz"
RadioFreq
SL&F=nnn.nnnn
n
Set active frequency to nnn.nnnnn
MHz
"OK" or "ERROR"
RadioFreq
SL&FR?
Get Rx frequency
"nnn.nnnnn MHz"
RadioFreq
SL&FR=nnn.nnn
nn
Set Rx frequency to nnn.nnnnn
MHz
"OK" or "ERROR"
RadioFreq
SL&FT?
Get Tx frequency
"nnn.nnnnn MHz"
RadioFreq
SL&FT=nnn.nnn
nn
Set Tx frequency to nnn.nnnnn
MHz
"OK" or "ERROR"
RadioFreq
SL&W?
Get channel spacing/channel
width
"25.0 kHz", "12.5 kHz"
RadioFreq
SL&W=xxxx
Set channel spacing. Value of xxxx
is:
”1250” for 12,5 kHz
”2500” for 25 kHz
Before using this command, make
sure that active frequency matches
new channel spacing
"OK" or "ERROR"
RadioProperty
SL%F?
Get status of Error correction (FEC)
"0" = FEC OFF , "1" =
FEC ON
RadioProperty
SL%F=x
Set Error correction (FEC). Value of
x is:
"1" Set FEC ON
"0" Set FEC OFF
"OK" or "ERROR"