User manual

SATEL INTEGRA Plus 37
6.1.4 Sound signaling
Beeps generated when operating
The installer can disable the sound signaling or replace it with blinking of the keys
backlight.
1 short beep – pressing any digit key, confirmation that code has been entered or card has
been read.
2 short beeps – acceptance of the first code during two code arming / disarming.
3 short beeps – signaling of:
– starting the procedure of arming (if no exit delay time has been programmed for the
partition, this is equivalent to arming),
– disarming and/or alarm clearing.
4 short and 1 long beeps – confirmation that the function has been executed.
3 pairs of short beeps – the user should change his/her code.
1 long beep – refusal to arm (there are violated zones in the partition or there is a trouble).
2 long beeps – unknown code/card.
3 long beeps – unavailable function.
Events signaled by sounds
Only installer selected events are signaled.
Alarms are signaled for the time programmed by the installer.
5 short beeps – zone violation (CHIME).
Long beep every 3 seconds, followed by a series of short beeps for 10 seconds
and 1 long beep – countdown of exit delay (if the time is shorter than 10 seconds, only
the final sequence of short beeps will be generated).
A sequence of 7 beeps of diminishing duration, repeated every few seconds –
countdown of auto-arming delay.
2 short beeps every second – countdown of entry delay.
Continuous beep – alarm.
Long beeps every 2 seconds – alarm memory.
Long beep every second – fire alarm.
Short beeps every 2 seconds – fire alarm memory.
Very short beeps – door open too long.
6.2 Functions available from the partition keypad
6.2.1 [Code]
Depending on the user type and authority level, keypad settings and the alarm system status,
entering the code and confirming with the
key will result in:
– unlocking the door (activating the relay);
– disarming the partition;
– clearing alarm;
– changing over the status of 25. BI
SWITCH type outputs;
– turning on the 24. MONO
SWITCH type outputs;