Specifications

SATEL INTEGRA 128-WRL 5
− INT-KSG – 1.02 (or later).
The keypads are available in a variety of color options for the enclosure, display and key
backlight. The color variant is indicated by the additional designation in the keypad name
(e.g. INT-KLCD-GR – green display and key backlight; INT-KLCD-BL – blue display and key
backlight).
Features of the INT-KSG keypad are described in a separate manual, delivered with the
keypad.
3.1 Features of keypads with mechanical keys
• Display 2 x 16 characters with backlight.
• LEDs indicating the status of the partitions and the system.
• Backlit keys.
• Built-in sounder.
• 2 programmable hardwired zones:
– support for NO and NC detectors;
– support for Single EOL and Double EOL configuration.
• Tamper protection in 2 ways – cover removal and tearing enclosure from the wall.
• RS-232 port (PIN-5 socket) for administration of the security alarm system by means of a
computer with the GUARDX program installed.
4. Expansion modules
The expansion modules allow you to not only increase the number of available zones and
outputs (wired and wireless), but also enhance the system with additional functionality.
Not all of the following modules meet the requirements of EN 50131 for Grade 2.
4.1 Modules to be connected to the keypad bus
CA-64 PTSA. Mimic board. Enables visualization of the status of the alarm system partitions
and zones. The control panels support the mimic boards with electronics version 1.4 (or
later) and firmware version 4.0 (or later).
ETHM-1. Ethernet module. Enables reporting events as well as operating and programming
the control panel via the Ethernet network. The recommended module version: 1.06 (or
later).
INT-RS. Data converter. Makes it possible to connect the computer with the GUARDX
program installed in the same way as to the LCD keypad, report events through
a special external device, or operate the control panel using software other than that
offered by SATEL.
4.2 Modules to be connected to the expander bus
INT-RX / INT-RX-S. 433 MHz keyfobs receiver expansion module. Enables operation of
the alarm system using the 433 MHz keyfobs.
INT-CR. Proximity card arm/disarm device. Enables arming / disarming and alarm clearing
in many partitions by means of proximity cards, proximity tags and other passive
transponders.
INT-S / INT-SK. Partition keypad. Enables arming / disarming and alarm clearing in one
partition. Can perform access control functions.