Specifications

4 Installer Manual SATEL
– control the outputs (switching the lights on/off, watering the garden, etc.).
• Partition timers (1 for each partition), to allow automatic arming/disarming.
Programming
• Local programming:
– keypad;
– computer with the DLOADX program installed, connected to the control panel RS-232
port.
• Remote programming:
– computer with the DLOADX program installed, communicating via modem, by means of
GPRS or via the Ethernet network (optionally, if the ETHM-1 module is connected to the
control panel);
– internet browser (optionally, if the ETHM-1 module is connected);
– mobile phone with suitable application installed (optionally, if the ETHM-1 module is
connected ).
Mainboard
• RS-232 port (RJ type socket) to allow:
– local programming by means of a computer with the DLOADX program installed;
– local system administration by means of a computer with the GUARDX program installed;
– remote programming using the DLOADX program via Ethernet (TCP/IP), if the ETHM-1
module is connected;
– support for external analog, GSM or ISDN modem;
– serial printer connection (for printing current events).
• Capability of the firmware updating without the need for disassembly of the control panel.
• Socket for connecting the INT-VG voice module, CA-64 SM voice synthesizers expander
or SM-2 synthesizer.
• Real time clock with calendar and battery backup.
• LEDs indicating the status of outputs, battery charging system and telephone dialer.
• Electrical protection of all hardwired zones and outputs, and communication buses.
• Switching power supply with short-circuit protection, provided with a battery status
supervision and low battery disconnect system.
3. Keypads
The INTEGRA 128-WRL control panel supports the following keypads:
INT-KSG – LCD keypad with touch keys;
INT-KLCD – LCD keypad with mechanical keys;
INT-KLCDR – LCD keypad with mechanical keys and built-in proximity card reader;
INT-KLCDK – LCD keypad with mechanical keys;
INT-KLCDL – LCD keypad with mechanical keys;
INT-KLCDS – LCD keypad with mechanical keys.
The recommended version of the keypad firmware (provides functionality consistent
with the requirements of EN 50131 for Grade 2):
− INT-KLCD / INT-KLCDR – 1.08 (or later);
− INT-KLCDK / INT-KLCDL / INT-KLCDS – 6.08 (or later);