Specifications

SATEL INTEGRA 128-WRL 25
If an invalid serial number is entered, it will be indicated by a suitable message. In such
a case, enter the correct serial number and repeat the above mentioned step.
4. The message will confirm that a new device has been added. It will be assigned to the
first free zone from the pool reserved for the wireless devices. A suggested name for that
zone will appear (the name is editable). The name will be also assigned to the output, if
the device is to be assigned to the output. For some devices, you can also select whether
the device will take up one or two positions on the list of devices.
5. Click on the "OK" button to complete the procedure of adding a new device. You can
cancel adding the new device by pressing the "Cancel" button. You can also press the
"Next" button to immediately begin adding another wireless device.
5.13.2 Removing wireless devices
LCD Keypad
You can remove a wireless device in the service mode, using the REMOVE DEVICE function
(STRUCTURE HARDWARE EXPANDERS SETTINGS ABAX - INTEGRA REMOVE DEVICE).
1. Start the REMOVE DEVICE function.
2. Using the  and  keys, select the zone to which the wireless device to be removed is
assigned, and then press the key.
3. Press the key 1 to confirm that you want to remove the device (pressing another key will
take you back to the selection list).
4. The device will be removed. A message on the display will inform you that the expander
identification function has been started.
5. After identification of the devices, you will be brought back to the list of zones to which
wireless devices are assigned.
DLOADX program
You can remove a wireless device in the "Structure" window, "Hardware" tab, after clicking on
the „Wireless System”.
1. Click on the list on the wireless device to be removed (if the device takes up some
positions on the list, you can click on any of them).
2. Click on the "Remove device" button. The "Confirm" window will open.
3. Click on the "Yes" button. The device will be removed.
5.14 Connecting computer to the control panel
Using a computer, you can update the control panel firmware (FLASHX program), program the
control panel (DLOADX program) and administer the security system (GUARDX program).
Communication is encrypted. The computer can be connected to the control panel via the
RS-232 port.