Specifications

SATEL INTEGRA 128-WRL 11
5.4.1 Description of the mainboard
Explanations for Fig. 2:
battery connection cables (red +, black -).
LEDs indicating the status of high-current outputs.
pins for setting battery charging current:
− pins shorted (jumper on) – 400 mA
− pins open (no jumper) – 800 mA
CHARGE LED indicating the battery charging.
RS-232 port (RJ type socket).
STTS LED indicating the operation status of the supervision circuit of ABAX wireless
system.
RESET pins for emergency starting the control panel (see: EMERGENCY PROCEDURE OF
THE CONTROL PANEL START
-UP p. 20).
lithium battery for clock and RAM backup. Its removal will result in loss of the clock
settings and all data stored in RAM.
Insert the battery in its socket before starting the control panel.
socket to connect antenna for communication with ABAX wireless devices.
SIM card socket. It is not recommended to insert the SIM card into its socket before the
card PIN code has been programmed in the control panel.
GSM STATUS LED indicating the telephone and GSM network status:
− OFF – the telephone disabled,
− ON – outgoing voice call,
− lit, getting dimmed every 0.5 second – incoming voice call,
− flashing slowly – CSD communication,
− flashing rapidly – GPRS communication
− 1, 2, 3 or 4 flashes every 2 seconds – telephone standby mode (the number of
flashes indicates the signal strength).
LEDs indicating the status of low-current outputs.
socket for connecting the INT-VG voice module, CA-64 SM voice synthesizer expander
or SM-2 synthesizer.
socket for GSM/GPRS communication antenna.
Description of terminals:
AC - power supply inputs (18 V AC)
COM - common ground
OUT1...OUT2 - programmable high-current outputs (if output is not used, the 2.2 kΩ
resistor should be connected between the output and common terminals)
+KPD - power supply output for powering the devices connected to keypad bus
(13.6...13.8 V DC)