Specifications

8 Installer Manual SATEL
4.3 Wireless devices supported by the controller
Detectors
• AFD-100 – wireless water flood detector.
• AGD-100 – wireless glass-break detector.
• AMD-100 – wireless magnetic contact.
• AMD-101 – dual channel wireless magnetic contact.
• AMD-102 – wireless magnetic contact with input for roller shutter detector.
• APD-100 – wireless passive infrared detector.
• APMD-150 – wireless dual motion detector.
• ARD-100 – wireless reorientation detector.
• ASD-110 – wireless smoke and heat detector.
• ATD-100 – wireless temperature detector.
• AVD-100 – wireless vibration detector and magnetic contact.
Sirens
• ASP-105 – wirelessly triggered outdoor siren.
• ASP-205 – wireless indoor siren.
Other
• ACX-200 – hardwired zone / output expander.
• ACX-201 – hardwired zone / output expander with power supply.
• ARF-100 – radio signal level tester.
• ASW-100 E / ASW-100 F – 230 V AC wireless controller.
5. System installation
Disconnect power before making any electrical connections.
The following tools will be useful during installation:
• blade screwdriver 2.5 mm,
• Phillips screwdriver,
• precision pliers,
• flat nose pliers,
• driller c/w a set of drill bits.
5.1 Installation plan
The installation must be preceded by preparation of a plan of the security alarm system. It is
advisable to draw up a sketch of the premises and mark on it all the devices that are to be
included in the alarm system: control panel, keypads, detectors, sirens, expansion modules
etc. When planning the installation location for the control panel and wireless devices of the
ABAX system, you must take into consideration the range of radio communication.
Remember that thick masonry walls, metal partitions, etc. will reduce the range of radio
signal. The control panel and other alarm system components should be installed within the
protected area.