Specifications

SATEL GSM LT-1 27
DloadX key – the string of 12 alphanumeric characters (digits, letters and special characters)
defining the key with which the data sent to the D LOAD X program will be encrypted. The
module will only establish connection to the program using the correct key.
encrypted transmission – if this option is enabled, the data transmission between module
and program will be encrypted. The option must be enabled.
Communication Integra-GuardX
Server address – the address of computer with the G UARD X program, with which the module
(connected to the INTEGRA control panel through RS-232 port) is to communicate using
the GPRS technology. It can be entered as an IP address or as a name.
Server from SMS – if this option is enabled, the address of server, to which the module is to
connect, and the port number can be entered in the content of SMS message initiating the
connection. If the address is not entered, the module will connect to the computer whose
address has been programmed in the module.
Port – the number of port on which the communication with the G UARD X program will take
place.
Initiating SMS [121] – the control command that must be included in the SMS message sent
to the telephone number of GSM module connected to the control panel, so that the
module can establish communication with the G UARD X program using the GPRS
technology.
GuardX key – the string of 12 alphanumeric characters (digits, letters and special
characters) defining the key with which the data sent to the G UARD X program will be
encrypted. The module will only establish connection to the program using the correct key.
5.2.9 "Firmware update" tab
Fig. 15. "Firmware update" tab. The values shown are only an example.
Remote update of the module firmware by means of GPRS is possible for modules with the
u-blox LEON-G100 industrial GSM telephone.
Most of the parameters required to initiate the firmware update process can only be
programmed by means of the D LOAD 10 program.
For information on the firmware update server please visit the www.satel.eu site.
Update server – the address of server to which the module is to connect for firmware
update. It can be entered as an IP address or as a name.
Port – the number of server port shown in the form of decimal numbers.
SMS initiating update [118] – the control command that must be included in the SM
S
message sent to the telephone number of GSM module so as to initiate the firmware
update.