Specifications

20 GSM LT-1 SATEL
and the D LOAD 64 program (this applies to the CA-64 control panel firmware version
1.04.03 or newer, and the D LOAD 64 program version 1.04.04 or newer).
The SMS message sent to the module may have the following form: xxxxxx=yyyy. or
xxxxxx=yyyy=, where "xxxxxx" is the control command and "yyyy" is the computer
telephone number with which the control panel is to establish communication. If no
telephone number is given, the control panel will connect to the number programmed in
its memory. If the module receives an SMS message initiating connection with the
INTEGRA control panel, and the access to D LOAD X program is blocked, the module will
send an appropriate SMS message to the telephone number programmed using the
"Send SMS on change to" function (see: p. 20).
Call to user [05]
The control command can start the remote modem communication between the
INTEGRA control panel and the G UARD X program, or between the CA-64 control panel
and the G UARD 64 program (this applies to the CA-64 control panel firmware version
1.04.03 or newer, and the G UARD 64 program version 1.04.04 or newer).
The SMS message sent to the module may have the following form: xxxxxx=yyyy. or
xxxxxx=yyyy=, where "xxxxxx" is the control command and "yyyy" is the computer
telephone number with which the control panel is to establish communication. If no
telephone number is given, the control panel will connect to the number programmed in
its memory.
Change test period [27]
Using the control command, you can program the test transmission period. The SMS
message to be sent to the module must have the following form: "xxxxxx=P", where
"xxxxxx" is the control command, and "P" is the test transmission period:
0 – no test transmission,
1 – 2 h 58 min,
2 – 5 h 57 min,
3 – 11 h 56 min,
4 – 23 h 55 min,
5 – 2 d 23 h 53 min,
6 – 6 d 23 h 30 min.
Change tel. 1–4 [28]…[31]
Using the control command, you can program the phone numbers for test
transmissions. The SMS message sent to the module must have the following form:
"xxxxxx=yyyy." or "xxxxxx=yyyy=", where "xxxxxx" is the control command and "yyyy"
is the new telephone number for test transmissions. It is recommended that the
telephone number be preceded by the country code.
Send SMS on change to [26] – phone number to which the module will send confirmation
of execution of the control command (changing the modem format, programming the
test transmission period, programming the phone numbers for test transmissions)
received in the SMS message. The message sent by the module will contain
information on the current module state (see: "Remote control by means of SMS
message" p. 29). The entered phone number must be preceded by the country code.
SMS control onl
y from list of messaging tel. numbers [115] – if this option is enabled,
the SMS and DTMF control is possible from the telephone whose number is:
 one of the numbers to which the test transmission is sent (see: p. 21),
 number to which the SMS message confir
ming the module setting change received
in the SMS message is sent (see: "Send SMS on change to" p. 20),