Specifications

18 GSM LT-1 SATEL
PIN code [01] – PIN code of SIM card.
Entering a wrong code may result in blocking the SIM card.
SMS center no. [02] – telephone number of the short message service center (up to 16
characters). If the number has been written by the operator to the memory of SIM card
installed in the device, it need not be entered. In such a situation, the module will
download it automatically. Otherwise, it is necessary to enter the number, if the module is
to send SMS messages. It should be remembered that the number written into the module
must be suitable for the network in which the SIM card is registered.
Full, international number [10] – if this option is enabled, the SMS center number must be
entered as an international number (i.e. including the country code).
Fax/modem [11] – if this option is enabled, the module can be used as an external modem.
The module starts working in the modem mode on receiving the AT command, and stops
working in this mode when the DTR signal is lost.
Do not enable the "Fax/modem" option, if the module is working in conjunction with the
INTEGRA control panel (the control panel is connected to the module RS-232 port).
Modem format [08] – the transmission standard of the modem with which the GSM module
communicates. The format code is to be entered as 2 digits, according to the table below.
format code
modem format for GSM u-blox
LEON-G100 telephone
00 auto
04 2400 bps V.22bis
05 2400 bps V.26ter
06 4800 bps V.32
07 9600 bps V.32
12 9600 bps V.34
68 2400 bps V.110/X.31 flag stuffing
70 4800 bps V.110/X.31 flag stuffing
71 9600 bps V.110/X.31 flag stuffing
Table 1. Modem format codes for the GSM u-blox LEON-G100 telephone.
Access code [12] – a sequence of 6 alphanumeric characters starting the local DTMF
programming function. Entering the sequence from the keypad of telephone connected to
the phone line output will enable you to define the module settings. In the module with
factory default settings, the value 123456 is preprogrammed. You will be able to see the
value when you click on the button. If you delete the access code and quit the local
programming mode, any next changes in the settings, including the code restoration, will
only be possible by means of the D LOAD 10 program.
RS-232 baud rate [09] – the rate of data transfer through the RS-232 port.
PAGER station tel. no. [06] – the number after dialing of which by a device connected to the
telephone line output the module will simulate the pager station. The further part of the
dialed number will be treated as the cellular telephone number to which the PAGER type
message will be sent in the form of SMS message. The pager station number can consist
of up to 4 characters.
The programmed number must be unique and must not coincide with any other
number programmed in the module.
GPRS APN – access point name for Internet GPRS connection.