Specifications

SATEL GSM LT-1 15
In order to establish communication between the module and the computer do the following:
1. Start the D LOAD 10 program.
2. Select the "TCP/IP" in the "Communication" menu. A window will open in which
information on server activation will be displayed (see: Fig. 8).
Fig. 8. "TCP/IP" window.
3. Send to the GSM module telephone number an SMS message containing the control
command used to start communication with the D LOAD 10 program. The module will
connect to the computer whose address is programmed in the module.
If the "Server from SMS" ("TCP/IP downloading" tab) option is enabled in the modul,
you can send a message with the xxxxxx=aaaa:p. or xxxxxx=aaaa:p= content,
where "xxxxxx" is the control command used to initiate communication with the
D LOAD 10 program, "aaaa" is the address of computer with which communication is to
be established by the module, shown as an IP address or as a name, and "p" is the
number of network port through which communication with the D LOAD 10 program is to
take place. The module will connect to the computer whose address was given in the
SMS message (the computer address programmed in the GSM module will be
ignored). If the control command is correctly indicated in the SMS message, but the
other data are incorrect, then the address and port of the server with which
communication is to be established will be downloaded from the settings programmed
in the module.
5.2.3 Main menu of D LOAD 10 program
Fig. 9. Main menu of D LOAD 10 program.