Specifications

12 GSM LT-1 SATEL
 3. character – 3. phone number for test transmission (0 – no; 1 – yes);
 4. character – 4. phone number for test transmission (0 – no; 1 – yes);
 5. character – phone number for SMS control confirmation (0 – no; 1 – yes).
[117
**
] – 6 digits representing the SMS control command to be sent to the module to transfer
the network codes – USSD (see: "USSD codes forwarding message" p. 22).
[118
**
] – 6 digits representing the SMS control command to be sent to the module to initiate
the firmware update process (see: "SMS initiating updat
e" p. 27).
[119
**
] – 6 digits representing the SMS control command to be sent to the module to
establish communication with the D LOAD 10 program (see: "Initiating SMS" p. 26).
[120
**
] – 6 digits representing the SMS control command to be sent to the module to
establish communication with the D LOAD X program (see: "Initiating SMS" p. 26).
[121
**
] – 6 digits representing the SMS control command to be sent to the module to
establish communication with the G UARD X program (see: "Initiating SMS" p. 27).
5.2 DLOAD10 PROGRAM
The D LOAD 10 program version 1.00.039 is required for programming and configuration of the
GSM LT-1 module version 1.14. The program is delivered free of charge with the device.
Communication between the program and the module can be effected locally or remotely.
The module with factory default settings can only be programmed locally.
The program installation file can be found on the CD delivered with the module. You can also
download it from the www.satel.eu website. The D LOAD 10 program can be installed on the
computers running the Windows XP/VISTA/7 operating system.
Access to the program is protected with a password. During its first start-up, the program is
accessed with the factory default password: 1234 (you do not need to enter it, just click on
the "OK" button).
It is recommended that the factory password (access code) be changed. It can be
replaced with any sequence of 16 alphanumeric characters.
5.2.1 Local programming
1. Connect the module RS-232 port with the computer serial COM port (see: Fig. 5).
2. In the D
LOAD 10 program, "File" menu, first select "New device", and then "GSM-4/5/LT
module" (see: Fig. 6).
3. Press the key. The "Configuration" window will open.
4. Indicate the computer port to which the module is connected (see: Fig. 7).
5. Click on the "OK" button.
6.
Click on the button. The module data will be read out. Establishing communication
will be indicated in the program window by a suitable message.
7. Program suitable parameters for the module.
8. Click on the
button to write the entered data to the module.
9. The programmed data can be saved as a file to the computer disk.
When the programming is completed, disconnect the cable connecting the module to
the computer.