Specifications

8 GSM LT-1 SATEL
the required parameters. To enter digits, use the number keys. You can also enter special
characters:
# - press in turn the [
*
] and [1] keys;
*
- press twice the [
*
] key;
+ - press in turn the [
*
] and [0] key.
Having entered the data, confirm them using the [#] key.
When programming, the following sounds can be heard in the telephone handset:
3 short beeps – correct data;
2 long beeps – incorrect data.
For an overview of the other sounds generated by the module, please refer to the description
of functions [14] and [15].
In the case of parameter programming functions, pressing the [#] key just after the
function is started will reset the programmed values.
5.1.3 Function list
Shown in square brackets are key sequences used to start individual functions.
Shown after the dash is the parameter that can be programmed using the function.
[01
**
] – four-digit PIN code of SIM card.
[02
**
] – telephone number of the short message service center (see: "SMS center no. "
p. 18).
[03
**
] – 6 digits representing an SMS control command to be sent to the module to set the
modem format (see: "Set modem format" p. 19).
[04
**
] – 6 digits representing an SMS control command to be sent to the module to start the
remote modem communication between the INTEGRA control panel and the D LOAD X
program or between the CA-64 control panel and the D LOAD 64 program (see: "Call to
service" p. 19).
[05
**
] – 6 digits representing an SMS control command to be sent to the module to start the
remote modem communication between the INTEGRA control panel and the G
UARD X
program or between the CA-64 control panel and the G
UARD 64 program (see: "Call to
user" p. 20).
[06
**
] – a sequence of up to 4 characters (digits: 0-9 and characters: #,
*
, +), which – if
selected by the device connected to the telephone line output – will cause simulation of the
pager station by the module (see: "PAGER station tel. no." p. 18).
[08
**
] – 2 digits corresponding to transmission standard of the modem with which the GSM
module communicates (see: "Modem format" p. 18).
[09
**
] – parameter defining the data transfer rate through the RS-232 port:
0 – 4800 bps,
1 – 9600 bps,
2 – 19200 bps.
[10
**
] – parameter defining whether the programmed number of the short message service
center is a full international phone number:
0 – no,
1 – yes.
[11
**
] – parameter defining whether the module is to be used as an external modem (see:
"Fax/modem" p. 18):
0 – no,
1 – yes.