Manual

BG0509 REV. A2 11
Display Definitions
Press Display to set Brightness, Standby Mode and Language:
After setting these options, press
Save and then close the window by
pressing on the X in the top right
corner.
Screen Calibration
Press Calibration to calibrate the display touch screen sensor:
Follow the instructions on the
screen to calibrate the display. A
message will appear indicating if
input values are out of range.
Press OK to return to Display Setup
menu.
Network Setup
Press Network to define the network connection:
Press on the IP Address number to
define the address; input the correct
IP address (or press Clear to input a
new address) and press OK to save or
Cancel to restore the previous
address.
Define or change the Subnet Mask
number and Default Gateway in the
same manner.
DHCP – Press the setting (Off or On)
to change, then press OK to save.
Press X to close the window and
return to the Display setup menu.