Manual

Chapter 5 Configuring the EM920
Configuring Communications
66 EM920 Power Quality and Revenue Meter
Setting Up the Ethernet
Using the Front Display
Select Network Setup from the main menu. See Viewing and
Changing Setup Options in Chapter 3 for information on
navigating in menus.
See the table below for available network options.
Using PAS
Select Communications Setup from the Meter Setup menu,
and then click on the Network Setup tab.
The following table lists available network options.
Display Label Parameter Default
IP Address Device IP Address 192.168.0.203
Subnet Mask Network Subnet Mask 255.255.255.0
Default Gateway Network Default Gateway 192.168.0.1
NOTE
When you change the device network settings through the
Ethernet port, the device port restarts so communication will
be temporarily lost. You may need to wait some additional
time until PAS restores a connection with your device.