Users Manual

Satcube Ku User Manual v2.3-2020
SATCUBE PROPRIETARY
Document number: Satcube Ku User Manual v2.3-2020
Release date: 30th October 2020
Disclaimer
The information provided in this manual is for information purposes only. This document is subject to
change without notice and may contain errors or inaccuracies. Make sure to acquire the most
current version from the distributor before using the equipment.
This document is a user manual for the Satcube Ku terminal. It is important to observe all safety and
transmission requirements listed in this document and to operate the Satcube Ku according to the
guidelines provided in this manual.
Any responsibility or liability for loss or damage in connection with the use of this product and the
accompanying documentation is disclaimed by Satcube.
Satcube is not responsible for the content in any translation or reproduction of this manual from any
other source.
In Accordance with part 15 of the FCC rules
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.