Installation & Assembly

1. Turn power off at fuse or circuit breaker box.
2. Remove the j-box cover from existing frame housing.
3. Open quick case and remove quick-connect flexible whip.
4. Remove appropriate round knockout and connect the flexible
conduit whip to j-box with the provided snap-in connector. (Fig. 1)
5. Access the wiring compartment by removing a side to the J-Box.
6. Make wire connections between the conductors from the retrofit
quick connect and supply wires. Simply connect disconnect case
(Patent Pending) by Snap-On fit. Black = Line, White = Common
(Fig. 2)
7. Fasten the LED engine to the down light retrofit kit
utilizing the twist locking key holes.
8. With the fixture housing LED’s pointing down place
the trim ring concave up around the reflector.
9. Tuck the flexible conduit whip and the retrofit-kit into
the existing housing.(Fig. 3)
10. If the LED retrofit is not secured properly by existing hardware use supplied mounting clips from parts
bag to secure the reflector properly.
11. Supply power and enjoy new LED Down light Retrofit Kit.
NOTE: If no edge is visible attach angled brackets to the interior of the recessed fixture aperture using supplied
pan head screws, or other appropriate fastener as shown in figure 5. If previous methods do not create a
secured friction surface both retaining clips are mounted in combination. The tension clip is fastened on the
center of the angled bracket clip.
品名：说明书 品号：Y1397Z 双面印刷 A面 A版 曾建军12/30/2016