Installation Sheet

www.satco.comcustomer service 1-800-43-SATCO
2 3
Remove the installation
bracket from the back
of the fixture by turning
bracket counter-
clockwise.
Turn-off /disconnect
power at circuit breaker.
Attach connector
(provided)to AC
cable from junction box:
L side to Black AC wire
N side to White AC wire
Attach the bracket to junction
box using2 screws (provided)
Pull the AC cable with
connector throughthe bracket
center hole
Simply’click’the two
sides of the orange wire
connector together
Feed all wires up into
junction box as you raise the
fixture up into place
Align 3 ballbearings on the edge
of fixture with the slots on the
mounting bracket and TWIST
to lock fixture in place
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Connect ground from
fixture to grid with
twist-on connector
(provided)
This product is compatible with most residential type dimmers available on the market.
T he dimming performance will depend on kind of dimmer and dimmer settings.
• Clean with a soft or damp cloth. While cleaning with the damp cloth make sure
the power is off.
The purchased product is covered with a 5 year warranty in respect of any defect in material
or workmanship after purchase date.
Satco shall bear no responsibility on account of guarantee, as well as shall bear no
liability for any faults, in case of improper operation, use negligence, accident or
exposure to natural hazard, or excessive use over the limits specifed for the unit, or if
any unauthorized alteration or repair followed.
Dimming
Visit Satco.com for an up to date list of compatible dimmers.
5 Year limited warranty
• Do not clean with liquids or abrasives.
Cleaning