Installation Guide

STARFISH WIFI SMART

16' OUTDOOR STRIP LIGHT

Model: S11265

INSTALLATION AND SAFETY INSTRUCTIONS

IMPORTANT: Read before installing xture. Retain for future reference.

WARNING: Risk of Fire or Electric Shock

• Installation requires knowledge of luminaries electrical systems. If not

qualied, do not attempt installation. Contact a qualied electrician.

• To reduce risk of re and over-heating, secure all connections.

• TURN OFF the electrical power before proceeding.

• The electrical rating of this product is 120V/60Hz.

• The grounding and banding of the overall system shall be done in

accordance with National Electric Code (NEC) Article 600 and local codes.

• To prevent wiring damage or abrasion, do not expose wiring to edges of

sheet metal or other sharp objects.

• Do not make or alter any open holes in an enclosure of wiring or electrical

components during kit installation.

• This device is not intended for use with emergency exits.

• Suitable for wet locations.

NOTE: This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause harmful

interference; (2) This device must accept any interference received, including

interference that may cause undesired operation. Visit www.Satco.com for

full warranty details and dimmer compatibility information.

Pencil and screw driver required.

Satco Products, Inc.

PAGE 1
STARFISH WIFI SMART 16' OUTDOOR STRIP LIGHT Model: S11265 INSTALLATION AND SAFETY INSTRUCTIONS IMPORTANT: Read before installing fixture. Retain for future reference. WARNING: Risk of Fire or Electric Shock • Installation requires knowledge of luminaries electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician. • To reduce risk of fire and over-heating, secure all connections. • TURN OFF the electrical power before proceeding.
PAGE 2
INSTALLATION Before installation, select a location where you want to install, measure the required length of strip light, and mark it. Confirm that the adapter power cord will reach the desired power outlet and the LED strip light. Clean the mounting surface and keep it dry. It is important that the surface is smooth and clean before mounting the fixture. STEP 1: Turn power OFF before installing fixture. STEP 2: Find the desired place for the strip light and mark it clearly using the provided clips.