Installation Guide

STARFISH WIFI SMART 6' INDOOR STRIP,

OPTIONAL 3' EXTENSION

Model: S11263, S11264

INSTALLATION AND SAFETY INSTRUCTIONS

IMPORTANT: Read before installing xture. Retain for future reference.

WARNING: Risk of Fire or Electric Shock

• This strip lighting is only intended to be used with the products provided in the kit,

or the S11264 extension strips.

• This product consumes a total of 20W (.167A) and is rated to control up to 8

additional S11264 extension strips. Each extension strip consumes 8.8W (.075A).

• Installation requires knowledge of luminaries electrical systems. If not qualied, do

not attempt installation. Contact a qualied electrician.

• To reduce risk of re and over-heating, secure all connections.

• TURN OFF the electrical power before proceeding.

• The electrical rating of this product is 120V/60Hz.

• The grounding and banding of the overall system shall be done in accordance with

National Electric Code (NEC) Article 600 and local codes.

• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet

metal or other sharp objects.

• Do not make or alter any open holes in an enclosure of wiring or electrical

components during kit installation.

• This device is not intended for use with emergency exits.

NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful interference; (2)

This device must accept any interference received, including interference that may

cause undesired operation. Visit www.Satco.com for

full warranty details and dimmer compatibility information.

Satco Products, Inc.

PAGE 1
STARFISH WIFI SMART 6' INDOOR STRIP, OPTIONAL 3' EXTENSION Model: S11263, S11264 INSTALLATION AND SAFETY INSTRUCTIONS IMPORTANT: Read before installing fixture. Retain for future reference. WARNING: Risk of Fire or Electric Shock • This strip lighting is only intended to be used with the products provided in the kit, or the S11264 extension strips. • This product consumes a total of 20W (.167A) and is rated to control up to 8 additional S11264 extension strips. Each extension strip consumes 8.8W (.
PAGE 2
INSTALLATION Before installation, select a location where you want to install, measure the required length of strip light, and mark it. Confirm that the adapter power cord will reach the desired power outlet and the LED strip light. Clean the mounting surface and keep it dry. It is important that the surface is smooth and clean for proper adhesion. STEP 1: Turn power OFF before installing fixture. STEP 2: Adjust strip light length. It should only be cut in the designated locations.