User`s guide

7410F IFL Installation and User’s Guide Appendix IV 7100M Chassis
Foxcom Proprietary Information 52
Document No. 93-006-01-A
2. If the 7100M has Tx or Rx units only, place all jumpers on the lower two pins.
Figure 32 - Jumper Installation: Tx and Rx Only
3. If the 2000 Switch is installed in Slot 2, place the JP1 and JP2 jumpers on the higher two pins and the JP3 and JP4 jumpers on
the lower two pins.
Figure 33 - Jumper Installation: 2000 Switch in Slot 2
4. If the 2000 Switch is installed in Slot 5, place the JP1 and JP2 jumpers on the lower two pins and the JP3 and JP4 jumpers on
the higher two pins.