User`s guide

7410F IFL Installation and User’s Guide

Appendix III The 2380 Relay Adaptor

Foxcom Proprietary Information

Document No. 93-006-01-A

8. Appendix III The 2380 Relay Adaptor

The following section describes how to install the 2380 Relay Adaptor onto the

7180M Chassis. The 2380 Relay Adaptor assembly provides dry contact output

signals as an option to the standard open collector signals available on the 7180M

chassis backplane.

If the 2380 Relay Adaptor is ordered separately from the 7180M chassis, it must

mounted by the user. The 2380 is easily mounted directly over the connectors on

the 7180M backplane, as shown below.

8.1 Installing the 2380 - Parts Needed

• 2380 Relay Adapter

• Two pin guides

• Four one inch screws

• Screw driver

8.2 Installing the 2380 - Procedure

To mount to the 2380 Relay Adapter:

WARNING

DO NOT PERFORM THIS PROCEDURE BEFORE DISCONNECTING

THE ELECTRICITY

1. Disconnect the electricity.

2. Make sure that you have all the needed equipment.

3. Install the pin guides.

Figure 23 - Mounting the Chassis and Adaptor - Detail