Owner`s manual

11
Part No. 000911, 03-m12-2013 Multilift Mobile Owner’s Manual
Operate the Lift
Figure 5 shows the landing station (hall call) controls.
Figure 5
To operate the Multilift Mobile from the landing (call/send) station controls:
1 If necessary, call the lift to the landing where you will board.
a Insert the key into the call station and turn it to the operating position.
Note that the key is in the operating position when it cannot be pulled out.
b Press and hold the appropriate button to call the platform to the landing
where you will board the lift. Note that the lift will not move if one of the
gates is open.
3 When the lift arrives at the landing where you will board, the gate will
unlock and open automatically. If you need to reopen the gate after the
gate open delay is over, turn the key on and press the call button once again
to unlock and open the gate.
4 Board the lift and insert the key into the key switch on the cab operating
panel (COP). See the illustration on the next page.
5 Press and hold the appropriate landing button (1 or 2) to move the lift to the
desired landing.
Ensure the wheels are locked before operating the lift.
WARNING