Multilift Mobile OWNER’S MANUAL (To Be Retained by Owner After Installation by Authorized Savaria Dealer) Part No.
IMPORTANT Ensure that only an authorized Savaria Dealer installs and services the Savaria™ Multilift Mobile. Under no circumstances is anyone other than a dealer with Savaria training and authorization to install, adjust, service or modify any mechanical or electrical device on this equipment. Failure to follow this warning can result in safety system compromises or defeat; this can result in serious injury or death.
Table of Contents TO ENSURE SAFE OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 1. DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 2. GENERAL SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 3. OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TO ENSURE SAFE OPERATION To ensure safe operation of this equipment, pay careful attention to the important notes below. • Read this manual carefully before using the Multilift Mobile Mobile. • To prevent accidents, adhere strictly to the instructions and keep clear of moving parts at all times. • Follow instructions on all equipment labels at all times. Replace any damaged labels immediately. • Ensure that only qualified personnel perform maintenance. Multilift Mobile Owner’s Manual Part No.
1. DESCRIPTION Figure 1 shows the Multilift Mobile. Figure 1 Part No.
2. GENERAL SPECIFICATIONS Multilift Mobile Specifications Applications Residential (indoor/outdoor); commercial (U.S.A.) Load capacity 750 lb (340 kg) Maximum travel 48” (1219 mm) Levels serviced 2 Travel speed 8 ft/min (0.04 m/s) Platform size 36” x 48” (914 mm x 1219 mm) Side guard panels 42” (1067 mm) side guard panels on platform Cab access Front/rear access (platform Type 2) Power supply 120 VAC, 20 A, 60 Hz, single phase Drive system Acme screw and back-up nut 1 hp (0.
3. OPERATION Lower Wheels and Roll Lift Into Position 1 Lower the four lift wheels. For each wheel, place the hand crank on the wheel bolt and turn the crank to lower the wheels down to the floor. DANGER Be sure to keeps your hands and feet clear of the underside of the lift while lowering it to the floor. Figure 2 Hand crank Bolt Wheel Part No.
2 Roll the lift into position at the landing level where it will be used. Lock down the wheels as shown below. WARNING Be sure to lock down the wheels to avoid personal injury. Figure 3 Lock wheels 3 Ensure that the running clearance between the landing and the platform is 1/2” (12.7 mm). Multilift Mobile Owner’s Manual Part No.
Adjust Upper Limit Switch 1 Remove the switch positioning bar from its storage bracket and place it horizontally on the landing floor. See Figure 4 on the next page. 2 Rotate the limit switch handle counter-clockwise to loosen the entire switch assembly. 3 Slide the switch assembly down the track so the vertical bar of the switch assembly lines up with the switch positioning bar you placed on the landing floor.
Figure 4 Rotate limit switch handle CCW and slide assembly up or down to adjust limit switch position Limit switch cam Switch positioning bar in storage position Vertical bar of switch assembly Place switch positioning bar on floor at landing Multilift Mobile Owner’s Manual Part No.
Operate the Lift Figure 5 shows the landing station (hall call) controls. Figure 5 WARNING Ensure the wheels are locked before operating the lift. To operate the Multilift Mobile from the landing (call/send) station controls: 1 If necessary, call the lift to the landing where you will board. a Insert the key into the call station and turn it to the operating position. Note that the key is in the operating position when it cannot be pulled out.
6 When the lift arrives at the desired landing, the gate will unlock and open automatically. 7 To prevent unauthorized use of the lift, take the key out when the unit is not in operation.
4. SAFETY FEATURES Platform Gate The platform gate (shown in Figure 7) prevents the passenger from falling off the lift. Figure 7 GATE Safety Underpan The safety underpan (shown in Figure 8) is located under the platform. The underpan has sensors that detect any obstacles and stop the downward travel of the lift. Figure 8 Part No.
Gate Lock The WR-500 lock keeps the gate locked when the platform is moving and not at a landing. NOTE Keys are for emergency use only and should always be kept in a safe place for use by trained personnel only. Emergency Gate Opening The gate can be opened manually using the WR-500 lock emergency key provided (Figure 9). Insert the key into the lock and turn it a half turn clockwise to unlock the gate. Pull the gate open and then turn the key a half turn counter-clockwise to remove it from the lock.
Emergency Stop Button Pressing the red Emergency Stop button during travel will stop the lift immediately and activate the alarm. The Emergency Stop overrides the landing stations controls. To return the lift to normal operation, pull out the Emergency Stop button. Emergency Manual Lowering In an emergency situation, you can lower the platform manually using the hand crank provided (Figure 10). 1 Take off the cap and insert the hand crank as shown in Figure 9.
5. MAINTENANCE NOTE The owner can perform the 2-month inspections; 6-month inspections must be performed by a Qualified Technician. Contact your Authorized Dealer. Units installed in adverse environments will require additional maintenance on a monthly basis. Maintenance Schedule VERIFICATION BY OWNER Frequency Verify general operation of the lift.
Maintenance Record Date Time Reason for Call Part No.
Operator Troubleshooting The following table lists potential problems and their possible solutions. If the problem persists, contact your Authorized Dealer. Potential Problem Possible Solution Platform travels up but not down Check the underpan sensor operation. Pull down on the underpan to ensure the pan is not stuck in the activated position. Platform travels down but not up Check the power supply (breaker, cord, battery, etc.) Check that the key is ON (if applicable).
Multilift Mobile OWNER’S MANUAL Part No. 000911 Copyright 2013 Savaria Corporation Elevators and Lifts www.savaria.
