Owner`s manual

8
Multilift Owner’s Manual Part No. 000609, 03-m12-2013
Operating from the Landing Station Controls
Figure 3 shows the landing station (hall call) controls.
Figure 3
To operate the Multilift from the landing (call/send) station controls:
1 Insert the key into the key switch and turn it to the ON position to activate
the operating buttons.
2 Apply constant pressure on the appropriate button to call the platform to
the desired landing. Note that the Multilift will not move if one of the
doors/gates is open.
3 When the lift reaches the landing, the door will unlock automatically (for
units with mechanical GAL locks). For units with an electric strike, the door
will unlock automatically for a few seconds when the lift reaches the
landing. If you need to re-open the door after the delay, turn the key on and
press the call button again to unlock the door.
4 To prevent unauthorized use of the lift, take the key out when the unit is not
in operation.