Owner`s manual

7
Part No. 000609, 03-m12-2013 Multilift Owner’s Manual
3. OPERATION
Operating from the COP Controls
Figure 2 shows the Multilift car operating panel (COP).
Figure 2
To operate the Multilift from the COP controls:
1 Insert the key into the key switch and turn it to the ON position to activate
the operating buttons.
2 Apply constant pressure on the UP/DOWN switch (as required) to move the
platform to the desired landing. Note that the Multilift will not move if one
of the doors /gates is open.
3 When the lift reaches the landing, the door will unlock automatically (for
units with mechanical GAL locks). For units with an electric strike, the door
will unlock automatically for a few seconds when the lift reaches the
landing. If you need to re-open the door after the delay, turn the key to the
ON position and press the call button again to unlock the door.
4 To prevent unauthorized use of the lift, take the key out when the unit is not
in operation.
5 Pressing the Emergency Stop button during travel will stop the lift
immediately and activate the alarm (if equipped). The Emergency Stop
overrides the landing station controls. Pull the Emergency Stop out to
return the lift to normal operation.