Owner`s manual

Part No. 000609, 03-m12-2013 Multilift Owner’s Manual

5. MAINTENANCE

The owner can perform the 2-month inspections; 6-month inspections must

be performed by a Qualified Technician. Contact your Authorized Dealer.

Units installed in adverse environments will require additional maintenance

on a monthly basis.

Maintenance Schedule

Verification by owner Frequency

Verify general operation of the lift. Every 2 months

Verify correct operation of the safety devices:

• Underpan safety switches

•Door contact

•Door lock

•Emergency stop

Every 2 months

Verification by technician ONLY Frequency

Verify the following:

• General operation of the lift

• Operation of the underpan sensors

• Operation of the emergency stop

• Operation of the door and gate lock contacts. The lift

should not run unless the door or gate is closed and locked.

Every 6 months

Verify the safety components:

• Operation and alignment of the up final limit switch

(activate by hand)

• Operation of the back-up nut switch

• Operation of the load switch. Lower the platform to the

ground using the hand crank in order to release the load on

the main nut. The lift should not run up until you restore

the load on the main nut by moving the platform up with

the hand crank.

• Operation of the up relays. Verify that neither of the two up

relays gets stuck in the activated position. Use a multimeter

to verify that every N.O. contact is open when the relays are

not activated.

Every 6 months

Verify that all hardware is tightened. Every 6 months

Check the rollers (function and wear). Every 6 months

Check the battery fluid level (optional system). Also check the

voltage with the charger unplugged (13 VDC unloaded and no

lower than 10-11 VDC when running up/down).

Every 6 months

Lubricate the acme screw, and upper and lower bearings using

high-quality wheel bearing grease.

Every 6 months

NOTE