Specifications

PR 5220 Operating Manual Global SPM Variables

Sartorius 89

8 Global SPM Variables

For communication via OPC, the following variables are available:

BOOL R Digital input 1 X 0

BOOL R Digital input 2 X 1

BOOL R Digital input 3 X 2

BOOL W Digital output 1, transparent mode X 8

BOOL W Digital output 2, transparent mode X 9

BOOL W Digital output 3, transparent mode X 10

BOOL R Output Limit 1 X 16

BOOL R Output Limit 2 X 17

BOOL R Output Limit 3 X 18

BOOL R ADC error X 32

BOOL R Above Max X 33

BOOL R Overload, above (Max + plus the range that is still permissible) X 34

BOOL R Below zero X 35

BOOL R Zero +/- 1/4 d X 36

BOOL R Within the zero setting range X 37

BOOL R The weight is stable X 38

BOOL R Below zero or above Max X 39

BOOL R Load cell measuring signal negative X 40

BOOL R Load cell measuring signal > 36 mV X 41

BOOL R Internal arithmetic error; CAL data are perhaps faulty X 42

BOOL R ADC error, overload X 43

BOOL R Command error X 48

BOOL R Command active X 49

BOOL R Power fail signal X 50

BOOL R ADC test active X 56

BOOL R Calibration active X 57

BOOL R Instrument is tared X 58

BOOL R/W Read / write marker bit 1 X 64

BOOL R/W Read / write marker bit 2 X 65

BOOL R/W Read / write marker bit 3 X 66

BOOL W Switch to net weight X 72

BOOL W Set the instrument to zero X 112

BOOL W Set tare of the instrument X 113

BOOL W Reset the tare of the instrument X 114

BOOL W Start the ADC test X 115

BOOL W Finish the ADC test X 116

BOOL W Reset the power fail signal X 117

BOOL W Set the fixtare value as tare X 118

BOOL W Store the current gross weight in the fixtare memory (D31) X 119

BOOL W Start printing X 120

BOOL W Reset error X 121