Specifications

Commissioning PR 5220 Operating Manual
28 Sartorius
5.2.2 Searching the Instrument in the Network Using 'IndicatorBrowser'
The address can be determined using the 'IndicatorBrowser' (in a directory on the CD-ROM packed with the
instrument) program.
Install and start the 'IndicatorBrowser'.
When the instrument is connected to a network, it is
“default” in the DHCP mode, i.e. an address is assigned to it
by the server. This address, e.g. 172.24.21.85, can be
determined using the ‘IndicatorBrowser’ program.
5.3 Operation Using a PC
5.3.1 Operation Using the VNC Program
VNC stands for 'virtual network computing' and is a program for remote operation of computers.
The program distinguishes between the VNC server and VNC client (viewer). The server program is part of
the instrument software. The client program (viewer) must be installed and executed on the PC to be used
for operating the instrument.
For direct operation using the VNC program, the IP address
(extended by :1) must be specified when you run the
program, e.g. 172.24.21.85:1.
The address range of the
controlling PC can be limited
in the instrument; see Chapter
5.6.5.
The operator interface of the
VNC program appears: