Operating instructions

18
Installation of the Drive-on Ramp YAR 10 IS
To install the drive-on ramp, YAR 10 IS, use the angular braces and screws
provided. Proceed as shown in the diagrams below.
Loosely attach the angular braces (2) onto the frame of the weighing platform
using the hexagon bolts M8x80 (1), nuts and washers.
Place the side elements of the ramp on the bolts of the angular braces. Adjust
the height of the weighing platform from the ramp using the leveling feet and
securely tighten the fastening screws of the angular braces.