User manual

Information for the User
Cubis MSU Brief Instructions 27
Defining Balance Properties
General weighing settings: Here you can define the default settings for the general
device parameters. These settings can be changed within specific tasks when a new
task is configured.
h
The factory settings are indicated with *.
Adapt filter: This setting defines the measuring time of the balance to filter out
the effects of unfavorable weighing conditions such as drafts or vibration. Options:
Very stable/*stable/unstable/very unstable conditions
Application filter: Compensates for load fluctuations in the display. Options:
*Final readout/filling mode/low filtering/without filtering
Stability: The stability symbol is displayed when the weighing result is constant
within the defined stability range. Options: Maximum precision/very precise/
*precise/fast/very fast.
Stability delay: This setting lets you compensate for slowly abating
disturbances, such as turbulence in the weighing chamber of an analytical balance.
Options: *Very short/short/medium/long delay.
Zero/tare function: Defines conditions for taring the balance. Options:
Without/*after/at stability.
Automatic zeroing: If this option is enabled, changes of a fixed, configured
fraction of scale intervals per second starting from the display zero point are
automatically tared. Options: On/*off
Basic weight unit: Weight unit to be applied for this task. Options: All available
weight units, *gram.
Display accuracy: A lower display accuracy results in faster display of the value.
Options: *All decimal places/disable last decimal place
Tare/zero at power on: The balance is automatically tared when switched on.
Options: *On/off
Configuring the Leveling Function Q-Level
Here you can define the properties of the leveling function. Options: Off, no
function/*status display/warning message, repeated
Defining the Startup Mode of the Balance
Here you can select the mode that the balance should enter into when switched on
and upon repeated presses of the on/off button A. Options: OFF,ON,standby/
on, standby/always on
Configuring Printout Parameters
h
The factory settings are indicated with *.
Interface for print output: Connection of the printer used; options:
COM port A, B, C/file/SD memory card
Output protocol: Options: *Print/SBI/XBPI/Web Service/SICS/second display
Standard printout GLP: Defines when ISO/GLP output should be possible.
Options: *Off/enabled for cal.-adjustment/always enabled.
Taring after printout: Defines whether the balance is automatically tared after
a printout is generated. Options: *Off/on
Print event: Defines which event should trigger a printout.
Options: *Print button/start of the task/initialization of the application/result print