Operating instructions

67
Operating the Scale
Preparation
● Turn on the scale: press e
> The Sartorius logo is displayed
● Select the “Calculation“ application program in the Setup menu: press M
● Select the
Application parameters: press the q soft key 2 x,
then the O soft key once
● Select Application 1 (basic settings): press the O soft key
● Select Calculation: press the Q or q soft key, repeatedly, if necessary
● Confirm Calculation: press the O soft key
Calculation Decimal places None
in calculated result 1 decimal place
o 2 decimal places
3 decimal places
4 decimal places
5 decimal places
6 decimal places
7 decimal places
o = factory setting
see also the “Application Parameters (Overview)” in the chapter entitled
“Configuring the Scale”
● Save settings and exit the Setup menu: press the oo soft key
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during
alphanumeric input),
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
● Press the
isoTST soft key
> See “Calibration/Adjustment”
for further instructions
Toggling to the Next Application
● Press D
> See the section on the
corresponding application
program for further instructions
Setup (Setting Parameters)
● Press M
> See “Configuring the Scale” for
further instructions
Turning Off the Scale
● Press e
> The scale shuts off
> The display goes blank, then
OFF or Standby is displayed with
backlighting