Operating instructions

Function Keys (Soft Keys)
The current function of soft keys is
indicated in the bottom line of the
display (footer).
Texts (abbreviations) or symbols can
be displayed as in the example shown
below:
Texts (Examples)
isoTST:
Start calibration/adjustment
S ID: Save ID
The function keys are numbered from
right (F1) to left (F6).
Symbols
The bottom line shows the following
symbols:
oo Back to the initial state
(in the Setup menu: exit Setup)
o Go to the higher selection level
O Show sub-items under the active
item
Q Move upward in the input/output
window
q Move downward in the
input/output window
l Set the selected menu parameter
There are basically two different types
of displays:
– display for weights and calculated
values
– display for menu parameter settings
(Setup)
Operation
Display for Weights and Calculated
Values
Line for Metrological Data:
When the scale is used in legal
metrology, the following metrological
specifications of the weighing cell are
shown here:
Max Maximum capacity (upper
range limit) of the scale
Min Minimum capacity
(lower range limit) of the scale
(verified models only)
e Verification scale interval
(verified models only)
d Readability/scale interval
On standard scales, only
Max and d
are displayed.
Bar Graph:
The bar graph indicates how much of
the scale’s capacity is “used up” by
the current load; during
checkweighing, it indicates the
control limits.
The following symbols may be
displayed:
0% Lower load limit
100% Upper load limit
Bar graph showing 10%
intervals
- Minimum for checkweighing
= Target for checkweighing
+ Maximum for checkweighing
Plus/Minus Sign, Stability Symbol:
A plus or minus sign (
+ or -) is shown
here for a weight (or a calculated
value, such as that for counting), or
the S symbol indicating that a verified
scale has been zeroed or tared.
Line for Measured Values:
This area shows the weighed or
calculated value and the
alphanumeric input.
Note Concerning Verified Scales
Approved for Use as Legal Measuring
Instruments in the EU*:
For verified scales that have a
verification scale interval
e not
equal to the scale interval
d, the
last digit on the display is bordered.
* including the Signatories of the
Agreement on the European
Economic Area
Unit and Stability:
When the scale reaches stability, the
weight unit or calculated unit is
displayed here
When the a symbol is displayed
here, the value indicated in the
readout is not valid for legal
metrology.
4