Operating instructions

Getting Started

Cubis MSE Operating Instructions 15

Connecting the Weigh Cell to the Electronics Module/Evaluation Unit

t Connect the weigh cell and electronics module using the connection cable.

Make sure that the connectors click into place so that both ends are securely

connected.

Please check the plug contacts to ensure a proper connection.

There should be no tension on the connection cable.

We therefore recommend placing the device close to the wall.

t Connecting the Weigh Cell to the Evaluation Unit

Make sure that the connectors click into place so that the connection is secure.

Models with a separate electronics module (e.g. MSE6.6/3.6/2.7),

MSE225S/P and MSE125P: Do not replace the electronics module.

Replacing them with models from the ME/SE series, for example, can

damage the device.

Microbalances (Models MSE6.6S/3.6P/2.7S):

Placing Components on the Weigh Cell

t Install the following parts in the order listed:

1. MSE2,7S models: bush

2. Shield plate

3. Weighing pan

Note: After inserting the weighing pan, turn it slightly to the left and right,

while pressing it down lightly.

4. Internal draft shield (for MSE2.7S only)

5. Draft shield: Center the hole over the pan (see arrows)

Filter Balances (Models MSE6.6S-F/2.7S-F):

Placing Components on the Weigh Cell

t Place the components listed below inside the weigh cell in the order given:

MSE2,7S-F models: female connector

2. Shield plate

3. Internal draft shield

4. Filter weighing pan  50 mm or weighing pan

(optional filter weighing pan  75 mm or  90 mm)

Note: After inserting the pan, turn it slightly to the left and right,

while pressing it down lightly.

5. Draft shield cover

Tip: Turn the balance off and then on again after replacing the pan during

operation.

MSE6.6S/3.6P/2.7S:

MSE225…, MSx125:

MSE6.6S-F/2.7S-F:

MSE6.6S/3.6P/2.7S: