Operating instructions

Getting Started
Cubis MSE Operating Instructions 13
t Slide the upper draft shield panel into the guide rails from the rear while
pressing the locking tab.
t Slide the side draft shield panel into the guide rails from the rear while pressing
the locking tab.
y
This completes the balance assembly.
t Remove the panel again if necessary
1. Press on the locking tab.
2. Remove the panel again if necessary
t Place the panel in the storage slot at the back of the balance.
Assembly for Precision Balances without Draft Shield with a Weighing Range
up to 15 kg
t Fit parts onto the balance as shown in the picture.
1. Pan support
2. Shield plate/Draft shield
3. Weighing pan
t Place the pan support diagonally and press down lightly.
1. Pan
support
2
1
2
1
2
1
3
1