Operating instructions
24
Classification W
Digital I/O Interface
The Classification application supports
the digital input/output-interface.
There are 4 control lines, or outputs,
which are activated as follows (see also
the diagram below):
– With 3 classes:
– Class 1
– Class 2
– Class 3
– Set
– With 5 classes:
– Classes 1/2
– Classes 2/3/4
– Classes 4/5
– Set
In Setup, under:
Application:
Classific.:
Act.Ports.
you can define whether these control
ports are
– off,
– always on, or
– activated at stability.
The “SET” output normally changes its
voltage level when the current weight
exceeds the minimum load.
Alternatively, you can assign the
“Ready-for-use” function to this port.
Configured in Setup under:
Application:
Classific.: Set output
Digital I/O Interface
Control lines when working with 3 classes
Digital I/O Interface
Control lines when working with 5 classes
Class
1
2345
Min. load
Max. load
Set
Classes 1/2
Classes 4/5
Operative
Classes 2/3/4
Class
1
23
Min. load
Max. load
Class 2
Set
Class 1
Class 3
Operative