Operating instructions

The weighing platform is powered by the external industrial-grade ING 2 AC

adapter (see “Accessories”). Make sure that the voltage rating printed on this

unit is identical to your local line voltage. If the voltage specified on the label

or the plug design does not match the rating or standard you use, please

contact your local Sartorius office or dealer. To use a main feeder cable from

the ceiling or to mount a CEE plug, you will have to make arrangements

inside your facilities for installation of such cable equipment.

Use only original Sartorius AC adapters, identified by the Sartorius label. Use

of AC adapters from other manufacturers, even if these units have an

approval identification marking from a national testing laboratory, requires the

consent of a trained service technician.

For detailed information on further options for powering the equipment (e.g.,

using local low voltage), contact Sartorius headquarters in Germany or

one of the main offices based in your country.

The equipment must be connected to power in conformance with the

installation requirements of your country.

Safety Precautions

The Sartorius power supply rated to Industrial Class 2 (with safety extra-low

voltage emission (SELV)) can be plugged into any electrical outlet without

additional safety precautions. The ground or earth terminal is connected to

the platform housing, which can be additionally grounded, if required.

Install the power cable with adequate protection to prevent damage to the

cable.

Fixed Power Connection

If the power cable is permanently installed or secured so that it cannot be

unplugged, an emergency switch must be installed for disconnecting power to

the equipment. This emergency switch must be located near the weighing

platform and must be easily accessible. In addition, this switch must be

labeled as an emergency switch. All operators must be instructed in the use

of this switch.

Whenever possible, avoid wiring your weighing platform into networks that

carry a heavy load (such as a connection to a compressor or similar

equipment).