Operating instructions

19
In this case, notify your nearest Sartorius Service Center or the International
Technical Support Unit based in Goettingen, Germany. Maintenance and
repair work may be performed only by authorized Sartorius service
technicians who have access to the required maintenance manuals and have
attended the relevant service training courses.
Instructions for Recycling the Packaging
Sartorius products are packaged to ensure safe shipment using
environmentally friendly materials. After successful installation of the
equipment, you should return this packaging for recycling. For information on
recycling options, including recycling of old weighing equipment, contact
your municipal waste disposal center or local recycling depot.
C Marking
The
CC
CC
C marking affixed to the equipment indicates that the equipment meets
the requirements of the following Directive(s):
Council Directive 89/336/EEC “Electromagnetic Compatibility (EMC)”
Applicable European Standards:
Limitation of emissions: EN 50081-1 Residential,
commercial and light industry
EN 50081-2 Industrial environment
Defined immunity
to interference: EN 50082-1 Residential,
commercial and light industry
EN 50082-2Industrial environment
Important Note:
The operator shall be responsible for any modifications to Sartorius equipment
(not permitted on equipment to be verified) and for any connections of cables
or equipment not supplied by Sartorius and must check and, if necessary,
correct these modifications and connections. On request, Sartorius will
provide information on the minimum operating specifications (in accordance
with the Standards listed above for defined immunity to interference).
Pursuant to the German Directive for the Implementation of Regulations for
Prevention of Accidents, “Elektrische Anlagen und Betriebsmittel (VBG 4)”
(electrical installations and equipment) of April 1986, it is hereby certified that
the equipment delivered has been manufactured and tested in compliance
with the following DIN/VDE regulations:
DIN IEC 348/VDE 0411
Safety requirements for electronic measuring apparatus
DIN IEC 380/VDE 0806
Safety of electrically energized office machines
DIN IEC 601/VDE 0750
Safety of medical electrical equipment
and with Article 73/23/EEC, European Community Low Voltage Directive of
19 February 1973.
When you use electrical equipment in installations and under ambient
conditions requiring higher safety standards, you must comply with the
provisions as specified in the applicable regulations for installation in your
country.
Care and Maintenance