User manual

3.3.4. Reset button

To reset the dispenser, press the reset button on the

battery cover. The display shows E and TIP in blinking

form and pressing the tip ejector button will reset the

pipette to the d-mode.

NOTE: The dispenser should never be reset during

pipetting! Resetting will cause the plunger to move to

the home position and it will empty the contents of the

tip. The tip is also ejected in the end.

3.3.5. Start button

The start button triggers the aspiration and dispensing

operations according to the selected operating mode.

Only a soft touch is required to operate the button.

3. 3.6 . Tip att achment and ejection

Tip attachment

1. Push the tip into the tip connector. Make sure that

the tip is properly attached.

2. Confirm the tip size by double clicking the Start-

button according the instruction on the page 15.

Releasing the tip:

1. Press the Tip Ejection button. The tip is released

immediately.

NOTE: After the dispensing cycle has been completed

a small residual amount of fluid may have been left in

the tip. During the tip ejection it is possible that a part

of the remaining fluid comes out of the tip. Therefore

it is recommended that the tip ejection is performed

above a waste container.

4. Charging of the

Dispenser

The eLINE Dispenser Lite should be charged using the

original Sartorius Charging Stand, Charging Carousel

or AC-adaptor.