User manual

14
13. Confirm the programming by double clicking the
START-button
NOTE: Dispenser is now fixed to the selected tip
volume range
14. Place tip into the liquid and press START-button
to aspirate
15. Discard the prime excess by pressing the START-
button
16. To dispense, position the tip above the receiving
vessel and press START-button and repeat
until the cycle is completed
17. Finally position the tip to discard excess volume
and click twice the START-button
18. Now the Dispenser is ready for next pipetting cycle
NOTE: It is also possible to continue to aspirate and
dispense the same volume without the empty function.
To continue, keep the START-button pressed during the
last dispensing and within one second the direction
of the arrow will change. Keeping the START button
depressed, place the tip into the liquid again and then
release the START button to aspirate the next sample.
If you continue with the same tip
a. Change the volume by pressing
b. Confirm your selection by pressing
c. Change the number of aliquots by pressing
d. Confirm your selection by pressing
If you want to change the tip size or tip, go to step 1.
If you want to eject the tip, press
NOTE: It is possible to interrupt the dispensing
by pressing the ENTER button . The display
shows E and the tip can be emptied by pressing the
START button .
OUT
E
SPEED
IN
TIP SIZE
4.0 0 ml
3
10 ml
2 x
SPEED
OUT
TIP SIZE
4.0 0 ml
3
10 ml
2 x
SPEED
IN
TIP SIZE
4.0 0 ml
3
10 ml
2 x