User manual

8
When the dispenser is properly connected to the
charger, the led indicator lights up and stays on as long
as the dispenser is connected to the charger.
When the dispenser requires charging, the battery
symbol and “lo bat”-text will appear in the display. You
need to confirm that by pressing “enter”, only after
that you can complete your work, and/or start charging
the dispenser. Please note that if “enter” is not pressed
the dispenser will not start charging, even placed in
charging stand/connected to AC-adaptor.
Note: In case you continue to work with the dispenser
after the low bat-alarm, the battery will eventually be
completely discharged. Then the battery-symbol and
led indicator start to blink, and there is no response
from operating buttons. Charge the dispenser.
Initial charging of 30 minutes is required before use,
if the battery is totally discharged. During that time
the “Load”-text is displayed and you can’t use the
dispenser.
When the text disappears from the display, you can
continue to work with the dispenser keeping it still
connected to the charger.
4.1. Charging with the Sartorius
Charging Stand and Charging
Carousel
The charging stand and carousel are desktop charging
units.
The charging stand accommodates one and charging
carousel four eLINE Dispensers.
The charging stands and carousels operate through the
metal contacts placed in the sides of the Dispenser and
the head of the charging unit.
Before operating the AC-adaptor must be connected to
the socket at the rear of the charging stand as well as to
the electrical outlet. Before connecting the AC-adaptor
to the electrical outlet, check that its voltage setting
corresponds to the voltage setting of your electrical
outlet.
Led indicator
Battery symbol