Operating instructions

9
Installing the Verification Adapter for Use in Legal Metrology
(on verfiable models only)
§ Remove the nut located on the back of the indicator
§ Use the slotted screw to install the adapter plate
§ Place the verification seal over the adapter
Connecting the External Rechargeable Battery Pack (Accessory No. YRB10Z)
! Disconnect the indicator from power (unplug the power cord from the wall socket)
§ Installation
CISL1 | CISL2 models: Connect the 25-pin D-Sub connector (connecting cable
YCC02-RB01) from the battery pack to the second port (“UNICOM")
CIS1 | CIS2 models: Please see “Pin Assignment Chart" in this manual (via connecting
cable YCC02-RB02 or using option L2)
Operating the Battery Pack
– Hours of operation: up to 40, depending on the weighing platform connected; without
options). The indicator automatically switches to the battery operating mode (DC)
as soon as the mains power supply is cut off. It returns to the AC operating mode
automatically when power is restored.
Display symbols:
Fully charged:
Completely drained:
Connecting a Bar Code Scanner (Accessory No. YBR02CISL)
! Disconnect the indicator from power (unplug the power cord from the wall socket)
$ Installation
CISL2 models:
– Connect the 25-pin D-Sub connector from the battery pack to the second port
(“UNICOM")
– To connect both the bar code scanner and the external battery pack:
Use the YTC01 T-connector
CIS2 models: Please see “Pin Assignment Chart" in this manual (via connecting cable
YCC02-BR02 or using option 118)