Operating instructions

55
Operating the Combics 2
Setup
§ Turn on the Combics by pressing e
§ While all segments are lit, press the
) key
§ Select the Numeric menu: press the
) key 2 x
3 Application Parameters
3.5 Minimum capacity for automatic
taring and for automatic printout
3.5.1 1 digit
3.5.2 2 digits
3.5.3 5 digits
3.5.4 10 digits
3.5.5 20 digits
3.5.6 50 digits
3.5.7 100 digits
3.5.8 200 digits
3.5.9 500 digits
3.5.10 1000 digits
3.7 Automatic taring (first weight tared)
3.7.1 Off
3.7.2 On
3.8 Automatic start mode:
When switched on, the application
starts automatically with the previous
initialization data:
3.8.1 Automatic mode (On)
3.8.2 Manual mode (off)
4 Application Parameters 2
4.2 Check range
4.2.1 30% to 170%
4.2.2 10% to infinity
4.3 Switch control line “SET” to
4.3.1 Output “SET”
4.3.2 Ready
4.4 Control Lines
4.4.1 Off
4.4.2 Always activated
4.4.3 Activated at stability
4.4.4 Activated within check range
4.4.5 Activated at stability within
the check range
4.5 Parameter Input
4.5.1 Min, max, target value
4.5.2 Target value only with limits
in percent
4.6 Automatic Printout
4.6.1 Off
4.6.2 On
4.6.3 Only if within the
tolerance limits
4.6.4 Only if outside the
tolerance limits
§ Store settings and exit setup: press and
hold the ) key